i got these in backwards and adhesion was difficult to remove. ended up using alcohol to loosen and then when pulling the ball bearing rubber strips came out and that was a pain to reinstall. it would've been easier to pull out my drill. and now adhesion strips not working very well. probably find some gorilla glue
the adhesive stuck to the components that are supposed to slide. this product sucks and ruined my day! ugh. i just wrestled with this stupid thing for an hour and i'm so frustrated.
this was a nightmare from the beginning. no written instructions. no labeling back from front. i first put the adhesive tape on the gliders and adjusted the unit to fit and pull out of the cabinet perfectly except when trying to take it out of the cabinet it continually slid back and forth out of the correct width. i used packing tape to hold it in place and thought everything would be fine. it worked fine until i took the tape off the sticky part to attach it to the cabinet. i stuck it in place and it wouldn’t budge a fraction of an inch. it wouldn’t glide it was stuck in place. i finally ended up ripping off the bottom part of the gliders and pulled it out leaving the strips of ball bearings in the bottom of the cabinet. my husband finally took two putty knives to pull the tape out of the bottom of the cabinet never again. it would have been a great shelf well made and sturdy but at least label front from back if there is one and give some written instructions it’s now totally worthless
deep into description it mentioned fits cabinets totally flat on the bottom, missed that and now it is too late to return.also, adhesive strip came in 3 shorter pieces than packing slip indicated, 2 longer ones.
粘贴物难以去除
粘性不足
粘合问题
粘性问题
胶条短缺